News

Power plant desulfurization pumps are key equipment in flue gas desulfurization (FGD) systems, mainly used for conveying corrosive and abrasive med...

According to the characteristics of the slurry (such as particle size and concentration), impeller designs are divided into three types

To support the pump shaft, bear radial and axial loads, and ensure stability and alignment when the impeller rotates at high speed.

Works together with the casing to form a semi-closed flow path, allowing the slurry to run stably within this space;

The motor and pump are coaxially integrated, adopting a dry bottom pump design, and the entire unit operates submerged in water.

Removing sediment and sludge from the bottom to restore water capacity and ecological function.

Made of wear-resistant materials such as high-chrome alloy, white iron, or polyurethane, to withstand erosion from high-concentration (up to 60%) a...

Horizontal, single-stage single-suction, cantilever structure

After operation ends, run the pump in clean water for a few minutes to remove deposits inside the pump.

To identify a river sand pump (also known as a sand suction pump or gravel pump), it is necessary to make a comprehensive judgment based on its str...

Removing sediment and silt from the bottom of rivers, lakes, and reservoirs to ensure navigability and flood safety, such as the Pearl River Delta ...

The temperature rise of rolling bearings should not exceed 35°C, with a maximum temperature ≤ 80°C; sliding bearings ≤ 70°C.